Hand Lever Spring Setter
Hand Lever Spring Setter

This simple, economical device accurately presets a spring. It is very reliable and easy to use.

  • Standard 12″ range
  • Standard 5″ stroke
  • 750 lb load capacity
See all features

Hand Lever Spring Setter


This simple, economical device accurately presets a spring. It is very reliable and easy to use.

Parts and Accessories

Tester

DescriptionPart Number 
Hand Lever Spring Setter025-0000-0448-01Get a Quote

Factory Options

DescriptionPart Number 
Single Stop Rod025-0000-0293-00Get a Quote
Double Stop Rod025-0000-0333-00Get a Quote
Gear Rack with Thru-Rod Hole018-0000-2120-01Get a Quote

Accessories

DescriptionPart Number 
Platforms - 4" Ø

Platforms – 4″ Ø

Part Number: 025-0000-0191-00 A

For testing larger diameter compression parts.

025-0000-0191-00Get a Quote
Thru-Rod Support Kit (1/16 to 1/8" Ø x 6")

Thru-Rod Support Kit (1/16 to 1/8″ Ø x 6″)

Part Number: 025-0000-0225-00

Includes rods: 1/16, 3/32 & 1/8″ Ø x 4″ long, accompanying plates with matching holes, as well as upper and lower plates without holes.

025-0000-0225-00Get a Quote
4" Ø Platform / Thru-Rod Support Kit (1/16 to 11/16" Ø ID x 8")

4″ Ø Platform / Thru-Rod Support Kit (1/16 to 11/16″ Ø ID x 8″)

Part Number: 025-0000-0485-00

This kit is more flexible than other thru-rod options and can accommodate larger thru-rods. In addition, springs up to 4″ in diameter can be tested with the over-size platforms.

Includes rods: 1/16″ to 11/16″ x 8″ long, and accompanying plates with matching holes. 4″ Ø plate can double for testing springs with larger diameter.

NOTE: Deflection compensation is calibrated at the center of the platforms. The length error would vary depending on the load and the location of the load. A centered load is always best and will read accurately, to within ± 0.001″ (0.025 mm) of the actual length. A large off-center load near the edge of the extended platform may be off by up to 0.008″ (0.2 mm).

Installation & Use

025-0000-0485-00Get a Quote